Genesis Cable 21961002 Access Control Cable 18AWG

Product Description

The GENESIS CABLE 21961002 is a multi-conductor access control cable combining 18 AWG 4-conductor and 22 AWG 2-, 4-, and 6-conductor pairs in a single shielded assembly rated CMR for riser installations. This cable is designed for low-voltage access control, security, and intercom wiring applications where multiple signal types must run in the same conduit or wall cavity. The CMR rating qualifies it for vertical runs between floors in commercial and residential structures. Licensed low-voltage technicians and security system installers are the primary trades that specify and terminate this cable.

This cable is suited for access control panels, door controllers, card readers, and intercom systems that require both power and signal conductors in a single run. The combined 18 AWG and 22 AWG conductor configuration allows power-carrying conductors and lower-current signal conductors to share a common jacket. It is commonly used in commercial buildouts, office access control retrofits, and multi-door security installations where a single cable pull reduces labor and conduit fill.

Key Features

• CMR riser rating allows installation in vertical shaft and wall cavity runs per NEC Article 800
• Combined 18 AWG 4-conductor and 22 AWG 2-, 4-, and 6-conductor configuration in one cable
• Overall aluminum foil shield (1 shield) reduces interference on low-voltage signal conductors
• OAJ outer jacket provides mechanical protection for in-wall and conduit routing
• 1,000-foot reel quantity supports large commercial runs without mid-run splices

Compatibility

Designed for use in low-voltage access control, security, and intercom wiring systems requiring CMR-rated multi-conductor cable. Suitable for riser and in-wall installations governed by NEC CMR classifications.

Installation Notes

Installation must be performed by a qualified low-voltage technician in accordance with NEC Article 800 and applicable local codes. De-energize all connected panels and control equipment before terminating conductors. Maintain the foil shield continuity and drain wire connection at one end to prevent ground loops on signal pairs. Avoid exceeding minimum bend radius during pull-through to prevent conductor or shield damage.