General P1839-M 3.9mm Camera Probe DCS1800 DCS1600

Product Description

The GENERAL P1839-M is a 3.9mm diameter camera probe designed for use with compatible GENERAL inspection camera systems. This probe serves as a replacement or spare imaging head, allowing technicians to perform visual inspections in confined spaces such as pipe interiors, HVAC ductwork, wall cavities, and other hard-to-reach areas. At 3.9mm in diameter, the slim profile fits into tight passages where larger probes cannot reach. HVAC technicians, plumbers, and electricians rely on camera probe accessories like this to diagnose blockages, inspect flue passages, check conduit runs, and document conditions without destructive access.

The P1839-M is intended for use with the GENERAL DCS1800 and DCS1600 inspection camera systems. It is suited for residential and light commercial service applications where a compact camera probe is required. Typical installation scenarios include drain and pipe inspection, HVAC heat exchanger visual checks, electrical conduit verification, and general inspection tasks in confined or restricted-access locations.

Key Features

• 3.9mm probe diameter for access to tight or restricted spaces
• Compatible with GENERAL DCS1800 and DCS1600 inspection camera systems
• Sold as a single unit, suitable as a replacement or spare probe
• Lightweight at 2 pounds for easy handling during inspection tasks

Compatibility

Designed for use with the GENERAL DCS1800 and DCS1600 inspection camera systems as stated by the manufacturer.

Installation Notes

Installation and connection of the camera probe should be performed following the inspection system manufacturer guidelines. Power down or disconnect the base inspection unit before attaching or removing the probe to avoid damage to the connector or imaging components. A licensed HVAC technician, plumber, or electrician should verify probe compatibility with the host unit before use in a professional service application.