G E Lighting 93130867 Led T8 Tube 15W 1800 Lumens 2 Pack

Product Description

The G E LIGHTING 93130867 is a 15-watt LED T8 tube lamp sold in a 2-pack, designed as a direct replacement for 32-watt linear fluorescent tubes. Built with a glass T8 body and a bi-pin base, it delivers 1800 lumens per lamp with an adjustable color temperature ranging from 4000 to 6500 Kelvins, allowing technicians to dial in the right light output for the space. The CRI rating is 80, and the rated lamp life is 50000 hours. It is non-dimmable. The maximum overall length (MOL) is 48 inches. Licensed electricians and lighting contractors are the primary installers for this lamp type.

This lamp is suited for commercial and residential interior lighting applications where T8 fluorescent fixtures are already installed. It supports two installation modes: Type A operation using a compatible approved electronic ballast, or Type B direct-wire operation bypassing the ballast entirely. Typical install scenarios include office, retail, warehouse, and industrial overhead fixtures. The adjustable CCT feature makes it practical for retrofits where consistent color matching across zones is required.

Key Features

• 15-watt LED replaces 32-watt linear fluorescent — significant wattage reduction
• Adjustable color temperature: 4000 to 6500 Kelvins for flexible lighting setups
• 1800 lumens output per lamp
• Dual-mode: Type A ballast-compatible or Type B direct-wire installation
• Rated lamp life of 50000 hours reduces replacement frequency
• Non-dimmable — confirm dimmer compatibility is not required before install
• 2-pack packaging reduces per-unit handling on multi-fixture jobs

Compatibility

Designed for use in standard T8 bi-pin fluorescent fixtures. Supports Type A operation with an approved compatible electronic ballast, or Type B direct-wire operation with the ballast bypassed. Verify fixture type and wiring configuration before installation.

Installation Notes

Installation should be performed by a licensed electrician in accordance with NEC requirements. For Type B direct-wire installation, the ballast must be disconnected and bypassed — always de-energize the circuit at the breaker before beginning any wiring work. For Type A installation, confirm the existing electronic ballast is on the approved compatibility list for this lamp. Do not attempt to dim this lamp; it is rated non-dimmable and use with dimming controls may cause premature failure or unsafe operation.