Frigidaire 316580479 Range Spark Ignition Harness

Product Description

The FRIGIDAIRE 316580479 is a genuine OEM spark ignition switch harness assembly designed as a direct replacement for gas range ignition systems. This wiring harness routes power and control signals between the ignition switch and the spark module or burner igniters, maintaining the electrical integrity of the cooktop ignition circuit. Pre-terminated connectors allow for a clean, direct swap without splicing or fabrication. Licensed appliance technicians and experienced service pros handle this type of replacement as part of standard range service.

This harness assembly is suited for residential gas range applications where the original ignition wiring has failed, shorted, or been damaged by heat or mechanical wear. It is commonly installed during ignition troubleshooting when the switch, module, and igniters test good but the harness itself shows continuity faults or visible damage. This is a genuine Frigidaire and Electrolux replacement part, ensuring correct connector fitment and conductor sizing for the original circuit design.

Key Features

• Genuine OEM replacement from Frigidaire and Electrolux
• Pre-terminated connectors for direct plug-in installation with no splicing required
• Routes power and control signals between ignition switch and spark module or igniters
• Designed to maintain original circuit integrity and connector compatibility
• Suitable for service situations involving harness damage, heat degradation, or continuity faults

Compatibility

Designed as a genuine OEM-style replacement harness for Frigidaire and Electrolux residential gas ranges equipped with a spark ignition switch assembly. Consult the appliance model number and wiring diagram to confirm fitment before installation.

Installation Notes

Installation should be performed by a licensed appliance technician or qualified service professional. Disconnect the range from its power source and shut off the gas supply at the valve before beginning any disassembly. Route the replacement harness along the original path and secure any retaining clips or guides to prevent contact with hot surfaces. Verify connector seating at each termination point before restoring power and testing ignition function.