Freud PMAPC1010 Carbide Tipped Masonry Drill Bit 5 Pack

Product Description

The FREUD PMAPC1010 is a carbide tipped masonry drill bit designed for drilling clean, accurate holes in brick, block, and similar masonry materials. Measuring 1/8 inch in diameter and 3 inches in length, this bit features a hardened carbide tip that extends service life in demanding applications. Dual flutes channel dust and debris out of the hole during drilling, reducing clogging and improving hole quality. Sold in a pack of 5, this bit is a practical choice for contractors, masons, and trade professionals who need reliable performance on masonry substrates without frequent bit replacement.

The PMAPC1010 is suited for residential and light commercial masonry work where small-diameter pilot holes or anchor holes are required in brick veneer, concrete block, or similar materials. Typical applications include running conduit anchors, setting fasteners, or preparing holes for wall plugs in block or brick construction. This bit is intended for use with standard rotary drills in rotary mode only and is not rated for hammer or SDS drilling applications.

Key Features

• Carbide tip provides extended durability in hard masonry materials
• Dual flutes remove dust and debris for cleaner holes
• 1/8 inch diameter by 3 inch length for precise small-bore applications
• Rotary mode only — compatible with standard drill drivers
• Pack of 5 reduces downtime on multi-hole jobs

Compatibility

Designed for use with standard rotary-mode drills. Suitable for drilling into brick, concrete block, and similar masonry substrates. Not intended for use with hammer drills or SDS-style rotary hammer tools.

Installation Notes

Installation should be performed by a qualified tradesperson familiar with masonry drilling practices. Always use eye protection and appropriate dust control measures when drilling masonry. Operate the drill in rotary mode only — engaging hammer mode with this bit may cause tip damage or bit failure. Confirm anchor or fastener requirements before selecting hole diameter to avoid rework.