Freud DT256P1 T25 Torx Drive Bit 6 Inches 5 Pack

Product Description

The FREUD DT256P1 is a T25 Torx drive bit engineered for professionals who install and remove fasteners under high-torque conditions. At 6 inches in length, this bit is designed for use in cordless and corded impact drivers and drill drivers. The optimized tip geometry delivers a strong, precise grip that minimizes wear, stripping, and slippage during fastener engagement. A torque-resistant shank design absorbs rotational stress at the source, reducing tip fatigue during repeated tightening and removal cycles. Each package includes 5 bits.

This bit is suited for carpentry, decking, construction framing, and general fastening applications where T25 Torx fasteners are standard. The extended 6-inch length provides reach in recessed or hard-to-access fastener locations. The impact-rated shank construction makes it compatible with both impact drivers and standard drill drivers, covering a wide range of jobsite scenarios. Electricians, carpenters, HVAC installers, and general contractors will find this bit useful for panel work, equipment mounting, and structural fastening tasks.

Key Features

• T25 Torx tip profile for precise fastener engagement and reduced cam-out
• 6-inch length provides extended reach in confined or recessed areas
• Torque-resistant shank design absorbs stress to extend tip life
• Impact-rated construction compatible with cordless and corded impact drivers and drill drivers
• Optimized tip geometry reduces stripping and slippage during use
• 5 bits included per package for jobsite redundancy

Compatibility

Designed for use with standard 1/4-inch hex shank impact drivers and drill drivers, cordless or corded, accepting T25 Torx drive bits.

Installation Notes

Insert the 1/4-inch hex shank fully into the driver chuck before operating. Verify the correct Torx tip size matches the fastener recess before applying torque to avoid stripping. When using with an impact driver, apply steady forward pressure to maintain tip engagement throughout the drive cycle. Inspect bit tips regularly and replace worn bits to prevent fastener damage.