Freud DT152P1 T15 Torx Driver Bit 2 Inches 5 Pack

Product Description

The FREUD DT152P1 is a T15 Torx drive bit engineered for high-demand fastening applications in both corded and cordless impact drivers and drill drivers. At 2 inches in length, this bit features an optimized tip geometry that delivers a firm, precise engagement with T15 Torx fastener heads, reducing cam-out, stripping, and slippage during installation and removal. The torque-resistant shank design absorbs rotational stress at the connection point rather than at the tip, extending service life. Sold in a 5-piece pack, the DT152P1 is designed for tradespeople who cycle through fasteners at high volume and need consistent bit performance across repeated use.

This bit is suited for residential and commercial trade work wherever T15 Torx fasteners are specified. Common applications include HVAC panel fastening, electrical enclosure assembly, deck and structural fastening, and general mechanical assembly. The impact-rated construction makes it compatible with high-torque cordless impact drivers as well as standard drill drivers, giving installers flexibility across tool platforms. The 5-pack quantity supports extended job runs without interruption for bit replacement.

Key Features

• T15 Torx tip profile with optimized geometry for precise fastener engagement
• Torque-resistant shank absorbs stress to reduce tip wear during high-torque applications
• Impact-rated construction compatible with cordless and corded impact drivers and drill drivers
• Engineered for up to 50 times longer life compared to standard driver bits
• 2-inch length suits recessed and standard fastener access
• 5-piece pack for extended use without job-site interruption

Compatibility

Designed for use with T15 Torx fasteners in cordless and corded impact drivers and standard drill drivers across residential and commercial trade applications.

Installation Notes

Install and remove using a compatible cordless or corded impact driver or drill driver set to an appropriate torque clutch setting for the fastener size and material. Inspect bit tip for wear or rounding before each use, as a damaged tip increases the risk of cam-out and fastener damage. Do not use bits that show visible deformation or cracking.