Freud DT101P2 T10 Torx Drive Bit 1 Inch 2 Pack

Product Description

The FREUD DT101P2 is a T10 Torx drive bit designed for high-frequency fastener installation and removal in demanding trade applications. Each bit measures 1 inch in length and is built with an impact-resistant shank that absorbs torque, reducing stress at the tip during tightening and extraction cycles. The optimized tip geometry delivers a firm, precise seat in the fastener recess, minimizing wear, stripping, and slippage. This 2-pack is rated for use in both cordless and corded impact drivers and drill drivers, making it a practical consumable for electricians, plumbers, HVAC techs, and general construction crews who run fasteners at volume.

The DT101P2 is suited for residential and light commercial jobsite work where T10 Torx fasteners are standard. Common applications include electrical panel component mounting, equipment enclosure assembly, and general sheet metal or fixture work where a precise-fit Torx drive is required. The 2-pack format supports on-hand redundancy when bit wear is a factor in high-cycle impact driver use. The 1-inch length is compatible with standard bit holders and quick-release chucks on most cordless impact drivers.

Key Features

• T10 Torx tip with optimized geometry for precise fastener engagement and reduced stripping
• Torque-resistant shank design absorbs impact stress to extend tip life
• Impact-rated construction for use in cordless and corded impact drivers and drill drivers
• 1-inch length fits standard quick-release bit holders
• 2-pack quantity provides backup availability during high-cycle fastener work

Compatibility

Designed for use with standard 1/4-inch hex quick-release bit holders in cordless and corded impact drivers and drill drivers that accept T10 Torx drive bits.

Installation Notes

Install into a 1/4-inch hex quick-release bit holder before powering the tool. Ensure the fastener recess is clean and free of debris before engaging the bit to prevent tip wear and cam-out. Inspect the tip for wear after extended use in high-torque applications and replace when visible rounding or deformation is present. No power shutoff procedure applies to bit changes, but always follow tool manufacturer guidelines for bit insertion and removal.