Freud DPH32P5 No. 3 Phillips Drive Bit 2 Inches 5-pack

Product Description

The FREUD DPH32P5 is a 5-pack of No. 3 Phillips drive bits measuring 2 inches in length, engineered for professionals who drive and remove fasteners at high volume. These bits are built for use in both cordless and corded impact drivers and drill drivers. The optimized tip geometry provides a precise, close-fitting grip that minimizes cam-out, wear, and slippage under load. The torque-resistant shank design absorbs rotational stress at the body of the bit rather than the tip, reducing tip fatigue during repeated tightening and removal cycles.

These Phillips bits are suited for residential and light commercial construction, finish carpentry, decking, framing, and general fastening work where a No. 3 Phillips drive is required. The impact-rated construction makes them appropriate for high-torque cordless impact drivers as well as standard drill drivers. Each 5-pack provides redundancy for job site use, allowing crews to keep fresh bits staged across multiple tools without frequent restocking. They are a practical choice for electricians, plumbers, HVAC technicians, and general contractors who fasten equipment, panels, and fixtures as part of their daily workflow.

Key Features

• No. 3 Phillips tip sized for larger fasteners common in equipment mounting and structural applications
• Optimized tip design reduces cam-out, wear, and slippage during driving and removal
• Torque-resistant shank absorbs stress at the body rather than the tip for extended bit life
• Impact-rated construction compatible with cordless and corded impact drivers and drill drivers
• 5-pack quantity supports multi-tool staging and reduces mid-job downtime

Compatibility

Designed for use with standard 1/4-inch hex chuck impact drivers and drill drivers, cordless or corded, requiring a No. 3 Phillips drive bit.

Installation Notes

Insert the bit fully into the tool chuck and confirm it is seated before driving. When using an impact driver, match the drive size to the fastener head to avoid stripping. Inspect bit tips regularly and replace any bit showing visible rounding or deformation. No special certifications are required for bit replacement, but always follow the tool manufacturer's guidelines for accessory compatibility.