Freud DMAPLCH2010 Sds-plus Dual-tooth Flat Chisel

Product Description

The FREUD DMAPLCH2010 is a 3/4-inch by 10-inch SDS-Plus dual-tooth flat chisel designed for demanding demolition and chiseling work in concrete and masonry. The steel body undergoes a specialized heat treatment process that increases resistance to the high-stress impacts generated by corded and cordless rotary hammer drills. At 3.67 pounds, this chisel delivers the mass needed for effective energy transfer without excessive fatigue during extended use. It is suited for general contractors, masons, and concrete tradespeople who need a reliable chisel for high-cycle applications.

This chisel is used in residential and commercial concrete demolition, joint restoration, reinforcement clearing, and adjustment work on concrete surfaces. The dual-tooth jam-free head creates multidirectional fractures in concrete, accelerating material removal compared to single-tooth designs. The self-sharpening tip maintains cutting effectiveness over extended service life, reducing the frequency of chisel replacement on active job sites. It is optimized for use in corded and cordless SDS-Plus and SDS-Max rotary hammers.

Key Features

• Dual-tooth jam-free head creates multidirectional concrete fractures for faster material removal
• Heat-treated steel body withstands high-impact stress from rotary hammer drills
• Self-sharpening tip extends service life and maintains cutting productivity
• Compatible with corded and cordless SDS-Plus and SDS-Max rotary hammers
• Suited for demolition, joint restoration, reinforcement clearing, and adjustment work

Compatibility

Designed for use with corded and cordless SDS-Plus and SDS-Max rotary hammers in general concrete and masonry demolition applications.

Installation Notes

Installation of this chisel is performed by construction tradespeople and concrete contractors using SDS-Plus or SDS-Max rotary hammers. Before inserting or removing the chisel, power down and disconnect the tool from its power source or battery. Ensure the SDS chuck is clean and the chisel shank is fully seated and locked before operation. Work in concrete or masonry environments may require compliance with applicable OSHA silica dust control standards.