Freud DMAPL4210 Sds-plus Hammer Bit 5/8x6 in 3 Pack

Product Description

The FREUD DMAPL4210 is a 5/8-inch x 4-inch x 6-inch SDS-Plus hammer drill bit from the Diablo Rebar Demon line, featuring a 4-cutter full-carbide head designed for heavy-duty concrete drilling through rebar. The full-carbide head is produced using tri-metal diffusion bonding technology, which controls heat buildup and resists breakage under sustained impact. A precision-ground tip delivers the stability and accuracy needed for fast, clean holes in concrete with rebar, meeting ANSI standards for anchor setting applications. This bit is intended for use by concrete drilling contractors, electricians, plumbers, and general construction tradespeople who rely on high-output rotary hammer drills.

The DMAPL4210 is engineered for use in corded and cordless SDS-Plus rotary hammers operating at high impact energy. It is suited for residential and commercial concrete drilling where anchor setting in rebar-reinforced concrete is required. Each package contains 3 bits, making it practical for job sites where bit wear is a factor in productivity. The 5/8-inch diameter and 6-inch overall length make it a common size for anchor bolt and threaded rod installations in structural and mechanical applications.

Key Features

• Full-carbide head with 4-cutter geometry for fast material removal in rebar-reinforced concrete
• Tri-metal diffusion bonding technology reduces heat buildup and prevents head breakage
• Precision tip geometry meets ANSI standards for anchor setting accuracy
• Compatible with corded and cordless SDS-Plus rotary hammers
• Sold as a 3-pack for extended job-site availability

Compatibility

Optimized for maximum performance in corded and cordless SDS-Plus and SDS-Max rotary hammers.

Installation Notes

Installation should be performed by a qualified tradesperson familiar with rotary hammer operation and anchor-setting procedures. Before drilling, de-energize any embedded conduit, rebar, or utilities in the work zone and verify layout against structural drawings. Insert the bit fully into the SDS-Plus chuck until it locks before starting the tool. Follow applicable building code and anchor manufacturer requirements for minimum embedment depth and edge distance when setting anchors in reinforced concrete.