Freud DBH600 Magnetic Bit Holder 6 Inches

Product Description

The FREUD DBH600 is a 6-inch magnetic driver bit holder designed to extend reach in tight and hard-to-access fastening locations. A high-strength permanent magnet holds bits and fasteners securely, reducing wobble during screw and nut driving. The holder features a torque-resistant construction that absorbs rotational stress, protecting both the holder body and the installed bit. Compatible with cordless and corded impact drivers and drill drivers, the DBH600 is built for repeated use in demanding trade and job-site conditions. Each package contains 5 holders.

The DBH600 is suited for electrical, HVAC, plumbing, and general construction applications where standard-length bit holders cannot reach recessed fasteners or confined framing cavities. The 6-inch length provides meaningful reach extension over standard 1-inch or 2-inch holders without sacrificing shank stability. Professionals working with impact drivers in high-cycle fastening tasks will benefit from the increased shank durability this holder provides over conventional magnetic holders.

Key Features

• 6-inch length extends drill and driver reach into confined or hard-to-access areas
• High-strength permanent magnet provides secure, anti-wobble bit and fastener retention
• Torque-resistant design absorbs rotational stress to reduce wear on holder and bit
• Impact-strong construction delivers shank stability in both cordless and corded impact drivers
• Sold in a package quantity of 5 holders per unit

Compatibility

Designed for use with standard hex-shank driver bits in cordless and corded impact drivers and drill drivers across common trade and construction applications.

Installation Notes

Insert the hex shank of the DBH600 fully into the driver chuck and tighten securely before operation. Ensure the driver is powered off and the trigger is locked before changing bits. Inspect the magnetic tip for debris or metal shavings that may reduce holding force, and clear as needed between uses. No special tools or code compliance is required for installation of bit holders.