Freud DBD045125701C Masonry Cut-off Disc Type 27 10-pack

Product Description

The FREUD DBD045125701C is a Type 27 premium masonry cut-off disc designed for handheld angle grinders and cut-off tools. Measuring 4.5 inches in diameter with a 0.125-inch thickness and a 0.875-inch arbor bore, this disc is built on a premium aluminum oxide blend abrasive matrix. The fully reinforced construction is rated for handheld cut-off work, providing structural integrity under lateral stress during masonry cutting applications. Licensed HVAC, plumbing, and general trade contractors who regularly cut concrete block, brick, or stone will find this disc suited to confined-space and overhead work due to its compact 4.5-inch profile. Sold in a 10-pack quantity.

This disc is intended for cutting masonry materials including concrete, brick, block, and similar construction substrates. The Type 27 depressed-center geometry allows the operator to work at a lower cutting angle, which is useful when cutting in tight or restricted areas where a flat Type 1 disc cannot be positioned effectively. The 10-disc pack is suited to contractors who perform repetitive cuts across multiple work sites. The aluminum oxide abrasive blend is formulated to maintain consistent cut speed across the disc life cycle rather than cutting fast early and degrading quickly.

Key Features

• Type 27 depressed-center profile for low-angle cutting in confined or hard-to-reach areas
• Premium aluminum oxide abrasive blend for consistent cut rate and extended disc life
• Fully reinforced construction rated for handheld cut-off tool use
• 4.5-inch diameter with 0.875-inch arbor bore fits standard angle grinders
• 0.125-inch thickness balances cut speed with disc rigidity on masonry substrates
• Sold as a 10-pack for high-volume or multi-site cutting applications

Compatibility

Designed as a replacement or consumable cut-off disc for standard 4.5-inch angle grinders and handheld cut-off tools accepting a 0.875-inch arbor. Suitable for cutting concrete, brick, block, and similar masonry materials.

Installation Notes

Installation and disc changes must be performed by a qualified operator with the tool fully powered down and the power source disconnected. Verify the tool's rated RPM meets or exceeds the disc's maximum operating RPM before mounting. Always inspect the disc for cracks or damage before use and never use a damaged disc. Eye protection, a face shield, and appropriate respiratory protection are required when cutting masonry materials.