Freud DAG3020 Auger Bit 7/16 X 17-1/2 Inches 2 Pack

Product Description

The FREUD DAG3020 is a 7/16-inch by 17-1/2-inch auger bit engineered for drilling through nail-embedded wood in residential and commercial construction applications. The self-feeding dura-tip pulls the bit into the material, reducing feed pressure and operator fatigue. Dual cutting edges work in tandem to produce a clean, controlled bore, while deep flutes accelerate chip evacuation to sustain drilling performance across repeated holes on a single battery charge. Each package contains 2 bits. This bit is used by electricians, plumbers, and general contractors who need to route conduit, pipe, or wire through framed walls and floor assemblies where fasteners are present.

The DAG3020 is suited for both cordless and corded drill drivers and impact drivers operating in wood framing, engineered lumber, and wood members containing embedded nails or staples. The extended 17-1/2-inch length provides the reach needed to bore through double top plates, rim joists, and other thick assemblies common in residential rough-in work. The 7/16-inch diameter accommodates standard trade wire and tubing routing requirements.

Key Features

• Self-feeding dura-tip pulls the bit forward, reducing manual feed pressure
• Dual cutting edges deliver a smooth, consistent bore in nail-embedded wood
• Deep flute geometry accelerates chip evacuation for sustained performance
• Compatible with cordless and corded drill drivers and impact drivers
• Extended 17-1/2-inch length reaches through thick framing assemblies
• Sold as a 2-piece package

Compatibility

Designed for use in cordless and corded drill drivers and impact drivers. Suitable for applications in wood framing, engineered lumber, and nail-embedded wood assemblies typical of residential and light commercial rough-in work.

Installation Notes

This bit is installed by electricians, plumbers, and HVAC technicians during rough-in phases of construction. Ensure the drill or impact driver chuck is fully seated and tightened before operation. When boring through framing members that may contain hidden fasteners, reduce speed on initial contact to allow the dura-tip to establish a center point. Wear appropriate eye and hand protection when drilling through nail-embedded material.