Federal Signal 27XST-024R-MOD Explosion Proof Strobe 24V

Product Description

The FEDERAL SIGNAL CORPORATION 27XST-024R-MOD is a red explosion proof strobe light designed for use in hazardous location environments where standard signaling devices are not rated for use. Operating at 24 volts DC, this strobe provides visual alarm signaling in areas where flammable gases, vapors, or combustible dust may be present. The unit is engineered to contain any internal ignition source, preventing it from igniting the surrounding atmosphere. Electricians and industrial maintenance technicians install this type of device as part of a facility alarm or warning system in classified hazardous areas.

This strobe is intended for hazardous location applications including petrochemical facilities, refineries, wastewater treatment plants, grain handling operations, and other industrial environments where NEC Class and Division or Zone ratings are required for signaling equipment. The red lens provides a distinct visual warning signal. It is sold as a single unit and is suited for both new installation and replacement of existing explosion proof strobe devices in 24 VDC alarm circuits.

Key Features

• Explosion proof construction rated for hazardous locations
• Red strobe lens for high-visibility visual alerting
• 24 VDC operating voltage for compatibility with low-voltage alarm and control circuits
• Single-unit packaging suitable for direct replacement or new install
• Designed for industrial and commercial hazardous area signaling applications

Compatibility

Designed as an explosion proof strobe signal device for hazardous location visual alarm systems operating on 24 VDC circuits. No specific compatible model numbers or system families were identified in the available product data.

Installation Notes

Installation of explosion proof signaling devices in classified hazardous locations must be performed by a licensed electrician in accordance with NEC Article 500 and applicable Class, Division, or Zone requirements. De-energize the circuit completely before beginning any wiring work and verify lockout tagout procedures are followed. All conduit entries and sealing fittings must be completed per NEC requirements to maintain the explosion proof integrity of the enclosure. Do not modify the housing or substitute non-rated components.