Ergodyne 17924 Cut Resistant Gloves Large Ansi A6

Product Description

The ERGODYNE 17924 is a full-fingered, cut-resistant utility glove built for trade work that demands serious hand protection. Part of the ProFlex 812CR6 series, it carries an ANSI/ISEA Cut Resistance Level A6 rating, making it suitable for tasks involving sharp metal, glass, sheet goods, or abrasive materials. The palm features a next-generation Armortex backing layered over synthetic leather for protection against cuts, nicks, and scrapes. A polyester lining adds interior comfort during extended wear. The hook-and-loop cuff closure with a contrasting red cuff allows for quick, secure fit adjustment on the job. HVAC technicians, sheet metal workers, plumbers, electricians, and general trade pros can deploy this glove wherever cut and puncture hazards are present.

The ERGODYNE 17924 is designed for utility and construction trades in both residential and commercial settings. The rough grip surface aids control when handling sheet metal, conduit, pipe, lumber, and similar materials. The glove ships as a pair in size Large. Its uncoated palm design suits dry-environment handling tasks where tactile feedback matters. Jobs involving glass handling, metal fabrication, HVAC ductwork installation, or cable pulling are typical applications for this protection level.

Key Features

• ANSI/ISEA Cut Resistance Level A6 for high-cut-hazard environments
• Armortex-backed palm construction for cut, abrasion, and puncture defense
• ANSI/ISEA Puncture Resistance Level 3 rated
• ANSI/ISEA Abrasion Resistance Level 2 rated
• Full-finger coverage with synthetic leather palm and back
• Hook-and-loop red cuff closure for adjustable, secure fit
• Rough grip surface for positive control on dry surfaces

Compatibility

Designed as an OEM-style replacement or stocking glove for trade professionals requiring ANSI A6 cut resistance in a full-fingered utility format; sold as a pair in size Large.

Installation Notes

Inspect gloves for damage before each use and replace immediately if the Armortex layer or palm shows cuts, tears, or delamination. These gloves do not provide electrical arc flash protection and are not rated as a blood-borne pathogen barrier. Always verify that the glove protection level meets the specific hazard requirements of the task per OSHA 1910.138 or applicable site safety standards.