Emtek E4020HLOUS19RH Helios Touchscreen Electronic Lockset

Product Description

The EMTEK E4020HLOUS19RH is a right-hand single cylinder electronic lever lockset featuring a touchscreen keypad and the Helios lever design in a Flat Black finish. Built for residential and light commercial door applications, this lockset combines keypad-based access control with a traditional lever trim profile. It accommodates both 2-3/8 inch and 2-3/4 inch backset configurations and fits doors ranging from 1-3/4 inches to 2-1/4 inches thick. The unit ships as a complete assembly and is sold individually. Locksmiths, finish carpenters, and general contractors are the typical installers on new construction and remodel projects alike.

This lockset is suited for interior and exterior residential entry doors where keypad access is preferred over traditional keyed entry. The Helios lever style integrates cleanly with contemporary and transitional interior design themes. The right-hand designation applies to doors where the hinge is on the left when facing the exterior or pull side of the door. The Flat Black finish coordinates with modern hardware suites across door and cabinet applications. It is custom assembled to order at the manufacturer's Southern California facility.

Key Features

• Touchscreen keypad for code-based entry without a physical key
• Helios lever design in Flat Black finish for a clean, modern profile
• Dual backset compatibility: 2-3/8 inches and 2-3/4 inches
• Fits door thickness from 1-3/4 inches to 2-1/4 inches
• Single cylinder configuration with right-hand handing
• Custom assembled to order — not a stock off-the-shelf configuration

Compatibility

Designed for right-hand single cylinder door prep on doors 1-3/4 inches to 2-1/4 inches thick with either a 2-3/8 inch or 2-3/4 inch backset. Consult the manufacturer documentation to confirm handing and backset before ordering, as this unit is custom assembled and may not be returnable once built.

Installation Notes

Installation should be performed by a licensed locksmith or qualified finish carpenter familiar with electronic lockset wiring and door prep requirements. Power down or remove batteries before servicing the electronic components. Verify door handing and backset measurement before ordering, as custom-assembled units require accurate pre-order specification. Follow the manufacturer's installation guide for proper strike plate alignment and electronic component setup.