Emtek 86425US4 Cabinet Pull 4 in Center Satin Brass

Product Description

The EMTEK 86425US4 is the Alexander Cabinet Pull finished in Satin Brass, designed for cabinet doors and drawers in residential and light commercial interiors. This pull features a 4 inch center-to-center spacing and mounts with a clean, low-profile profile suited to both traditional and transitional cabinetry. At 7 inches in overall length and 0.1 pounds, it is a lightweight, easy-to-handle hardware component. Installation requires only basic hand tools and is typically completed by a finish carpenter, cabinetmaker, or experienced DIYer during a cabinet build or renovation.

The Alexander Cabinet Pull is appropriate for kitchen cabinets, bathroom vanities, laundry room cabinetry, and built-in furniture applications. The Satin Brass finish provides a warm, muted metallic tone that coordinates with a range of cabinet finishes and interior design styles. It is sold individually and suited for both new construction and retrofit installations where a consistent hardware profile is needed across multiple cabinet doors and drawers.

Key Features

• 4 inch center-to-center hole spacing for standard cabinet boring patterns
• Overall length of 7 inches with a width of 2.8 inches and height of 1.2 inches
• Satin Brass finish for a warm, understated metallic appearance
• Lightweight construction at 0.1 pounds per unit
• Sold as a single unit, suitable for phased or per-door purchasing

Compatibility

Designed as a standard replacement or new-installation cabinet pull for cabinetry with 4 inch center-to-center boring, compatible with typical residential and light commercial cabinet door and drawer configurations.

Installation Notes

Installation is performed by a finish carpenter, cabinetmaker, or qualified DIYer using a drill, screwdriver, and appropriate cabinet hardware template. Power down any adjacent electrical components before drilling into cabinetry near wiring. Verify center-to-center hole spacing matches existing or planned boring before installation. Use manufacturer-supplied or appropriately sized machine screws to secure the pull without over-tightening, which can crack cabinet face frames or drawer fronts.