Emtek 86360US14 Brass Bar Cabinet Pull Polished Nickel

Product Description

The EMTEK 86360US14 is a brass bar cabinet pull finished in Polished Nickel Lifetime, designed for cabinet doors and drawers in residential and light commercial interiors. It features a 4-inch center-to-center spacing between mounting holes, a total length of 6.5 inches, and a width of 1.5 inches. Weighing 0.45 pounds, this pull offers a solid, substantial feel consistent with brass construction. It is sold as a single unit and is typically installed by finish carpenters, cabinetmakers, or knowledgeable DIYers as part of a cabinet hardware replacement or new installation project.

This bar pull is suited for kitchen cabinets, bathroom vanities, furniture, and built-in cabinetry where a clean, linear profile is desired. The Polished Nickel Lifetime finish provides a bright, reflective surface that coordinates with a wide range of fixture and appliance finishes. The 4-inch center-to-center dimension is a common standard spacing, making this pull a practical fit for many existing cabinet door and drawer configurations.

Key Features

• Brass construction for durability and consistent finish adhesion
• 4-inch center-to-center hole spacing for standard cabinet configurations
• Polished Nickel Lifetime finish for a bright, corrosion-resistant surface
• Overall length of 6.5 inches with a low-profile 0.5-inch height
• Sold individually, allowing precise quantity ordering per project

Compatibility

Designed as a standard-mount bar pull for cabinet doors and drawers with 4-inch center-to-center hole spacing, suitable for residential and light commercial cabinetry applications.

Installation Notes

Installation is typically performed by a finish carpenter or cabinetmaker using a drill, screwdriver, and hardware template for accurate hole placement. Power to any nearby electrical components should be shut off before drilling into cabinetry near wiring. Use the manufacturer-supplied or appropriately sized machine screws to avoid stripping the brass threads. Do not overtighten fasteners, as this may damage the finish or distort the pull.