Emtek 86267US15 Cabinet Pull 10 in Center Satin Nickel

Product Description

The EMTEK 86267US15 is a Trinity cabinet pull finished in Satin Nickel, designed for use on cabinet doors and drawers in residential and light commercial applications. With a 10-inch center-to-center spacing, this pull suits standard cabinet configurations common in kitchens, bathrooms, and built-in cabinetry. The Satin Nickel finish provides a brushed, low-sheen appearance that complements a wide range of hardware finishes and cabinet materials. The Trinity design features a clean, linear profile suited to both transitional and contemporary interiors. Installers and finish carpenters work with this pull when specifying or replacing cabinet hardware during renovation, new construction, or millwork projects.

This cabinet pull is intended for use on overlay and inset cabinet doors and drawer fronts where a 10-inch center-to-center hole spacing is required. It is sold as a single unit and is appropriate for residential kitchens, bathrooms, laundry rooms, and built-in furniture applications. The Satin Nickel finish coordinates with brushed nickel plumbing fixtures and other US15-finish hardware throughout a space. Custom assembly at the manufacturer facility means individual units are built to order rather than pulled from pre-packaged stock combinations.

Key Features

• 10-inch center-to-center spacing for standard cabinet door and drawer configurations
• Satin Nickel (US15) finish with a brushed, low-sheen surface
• Trinity profile with a clean, linear design suited to transitional and contemporary cabinetry
• Overall length of 13.7 inches accommodates grip area beyond the mounting holes
• Lightweight construction at 0.3 pounds for easy single-handed installation
• Sold individually, allowing mix-and-match hardware specifications per project

Compatibility

Designed as a standard replacement or new-installation cabinet pull for cabinet doors and drawer fronts requiring a 10-inch center-to-center hole pattern. Verify existing hole spacing or pre-drill to 10 inches on center before installation.

Installation Notes

Cabinet pulls of this type are typically installed by finish carpenters, cabinet installers, or experienced DIYers using a drill, appropriate bit, and a cabinet hardware jig for consistent hole placement. Mounting screws are commonly supplied separately or specified by the installer based on cabinet door thickness. Ensure cabinet door or drawer front material is adequate thickness to accept the machine screws without breakthrough. No electrical shutoff or plumbing isolation is required for this hardware type.