Emtek 5109STUUS10BLH Stuttgart Lever Passage Oil Rubbed Bronze

Product Description

The EMTEK 5109STUUS10BLH is a Stuttgart-style lever passage set in an Oil Rubbed Bronze finish, designed for interior doors that require a passage function without a locking mechanism. Configured for left-hand operation, the set ships with a 2-3/8 inch backset and mounts on a Disk Rose. It is suited for doors ranging from 1-1/4 inches to 2 inches in thickness. The lever and rose are assembled to order and sold as a single unit. Installation is handled by residential finish carpenters, interior trim contractors, or experienced general contractors performing door hardware replacement.

This passage set is intended for interior, non-locking door applications such as hallways, closets, and common-area doors where a turning lever is required to operate the latch but no key or thumb-turn lock is needed. The Stuttgart lever profile pairs with the low-profile Disk Rose for a clean, minimal presentation. The Oil Rubbed Bronze finish suits transitional and traditional interior design schemes. The left-hand configuration must be confirmed against the door handing convention used on the job before ordering.

Key Features

• Passage function — lever operates latch with no locking mechanism
• Left-hand configuration for correct lever orientation on hinge-side-identified doors
• 2-3/8 inch backset compatible with standard interior door prep
• Disk Rose provides a low-profile mounting surface at the door face
• Fits door thicknesses from 1-1/4 inches to 2 inches
• Oil Rubbed Bronze finish for transitional and traditional interior applications

Compatibility

Designed for interior passage door applications on doors from 1-1/4 inches to 2 inches thick with a standard 2-3/8 inch backset bore preparation. Verify door handing before installation to confirm left-hand fit.

Installation Notes

Installation is typically performed by a finish carpenter or door hardware installer. Confirm door handing and backset measurement before beginning installation. Disengage the door from use and ensure the latch bore and cross-bore are properly prepared to accept the hardware. Follow the manufacturer-supplied template and instruction sheet included with the unit for correct rose and lever alignment.