Emtek 5109HECUS15RH Hercules Lever Passage Set Satin Nickel

Product Description

The EMTEK 5109HECUS15RH is a right-hand passage lever set built around the Hercules lever design and finished in Satin Nickel. It is configured for a 2-3/8 inch backset and mounts on a Disk Rose, making it a clean, low-profile trim choice for interior passage doors where a latch function is required but no locking mechanism is needed. The lever set fits doors ranging from 1-1/4 inches to 2 inches thick. Custom assembled in Southern California, each unit ships as a single set ready for installation by a finish carpenter, general contractor, or skilled DIYer.

This passage set is suited for residential interior doors — hallways, closets, living spaces, and other areas where privacy hardware is not required. The Disk Rose trim keeps the wall plate minimal and geometric, pairing well with contemporary or transitional interior design schemes. The Satin Nickel finish provides a brushed, low-sheen appearance that resists visible fingerprints and integrates with a wide range of interior metal accents. The right-hand designation applies to the handing of the lever return and should be confirmed against the door swing before ordering.

Key Features

• Hercules lever design on a Disk Rose trim plate for a clean, geometric profile
• 2-3/8 inch backset fits the most common residential door prep
• Accommodates door thickness from 1-1/4 inches to 2 inches
• Passage function — latch only, no lock cylinder
• Satin Nickel finish with brushed low-sheen appearance
• Right-hand configuration — verify door handing before installation

Compatibility

Designed as a passage lever set for standard residential interior doors with a 2-3/8 inch backset and door thickness between 1-1/4 inches and 2 inches. Confirm door prep, handing, and rose mounting hole pattern before installation.

Installation Notes

Installation is typically performed by a finish carpenter or experienced DIYer using a drill, hole saw, and chisel for mortising the latch plate. Confirm the door handing and backset measurement before mounting. Disengage the latch mechanism and remove any existing hardware before fitting the new set. Follow the manufacturer's instruction sheet included with the unit for proper spindle alignment and rose fastener torque guidance.