Emtek 2241US3NL Hinge Pivot Stop Unlacquered Brass

Product Description

The EMTEK 2241US3NL is a hinge pivot stop designed to control door swing by limiting travel at the hinge side of the door. The stop mounts near the hinge point and prevents the door from opening beyond a set position, protecting walls, trim, and adjacent fixtures from impact damage. At 2.7 inches in length and 1.9 inches in width, it is a compact hardware component suited for standard residential and light commercial door installations. The unlacquered brass finish provides a natural, raw brass appearance that will develop a patina over time. This piece is sold individually and is installed by finish carpenters, general contractors, or experienced tradespeople performing door hardware work.

The 2241US3NL is appropriate for interior door applications where a hinge-mounted stop is preferred over a floor or wall stop. Typical scenarios include hallways, bedrooms, and utility spaces where wall protection is needed without the footprint of a surface-mounted floor stop. The unlacquered brass finish suits transitional and traditional design environments where an aged or living finish is desired.

Key Features

• Hinge-side pivot stop design keeps door swing controlled without floor or wall hardware
• Unlacquered brass finish develops a natural patina over time
• Compact profile at 2.7 inches long and 1.9 inches wide
• Low profile height of 0.7 inches minimizes visual footprint
• Lightweight construction at 0.1 pounds
• Sold individually, compatible with standard hinge pin configurations

Compatibility

Designed as an OEM-style hinge pivot stop for standard residential and light commercial interior door hinges. Verify hinge pin diameter and door clearance before installation.

Installation Notes

Installation is typically performed by a finish carpenter or experienced handyperson during door hardware fitting. Confirm the door swing clearance and hinge pin compatibility before mounting. No power tools are required for most installations, though a screwdriver and level are commonly used. Remove any existing door stop hardware before fitting the pivot stop to avoid interference.