Empire 310G0200 Emlok Swivel Ring Hanger 2in Pipe

Product Description

The EMPIRE 310G0200 is an Emlok swivel ring hanger designed to support 2-inch nominal pipe in mechanical, plumbing, and HVAC piping systems. The swivel design allows the ring to rotate, accommodating slight misalignment during installation and reducing stress on the pipe. Constructed from carbon steel with a pre-galvanized finish, this hanger delivers corrosion resistance in standard indoor and light commercial environments. It accepts a 3/8-inch threaded rod and carries a rated load capacity of 600 pounds, making it suitable for heavier pipe runs including filled steel, copper, and insulated lines. cULus Listed and FM Approved for use in regulated installations.

This hanger is used in residential and commercial mechanical systems wherever suspended pipe support is required. Typical applications include suspended ceiling installations, mechanical room pipe runs, and multi-trade rough-in where inspectors require listed hardware. The 3/8-inch rod size is standard in light-to-medium pipe support assemblies. Plumbers, pipefitters, and mechanical contractors install this fitting as part of a complete hanger rod and insert assembly.

Key Features

• Swivel ring design accommodates pipe alignment variation without stressing the support point
• 600-pound load capacity rated for filled pipe and insulated line sets
• Carbon steel construction with pre-galvanized finish for corrosion resistance
• Accepts standard 3/8-inch threaded hanger rod
• cULus Listed and FM Approved for use on code-required installations
• Designed for 2-inch nominal pipe size

Compatibility

Designed as an OEM-style replacement and new-installation hanger for 2-inch nominal pipe systems using 3/8-inch threaded rod support assemblies in plumbing, HVAC, and mechanical piping applications.

Installation Notes

Installation is performed by licensed plumbers, pipefitters, or mechanical contractors following applicable IPC and IFGC support spacing requirements. Power down or isolate any systems tied to the pipe run before making adjustments to existing support points. Ensure the threaded rod is fully engaged and the swivel ring is seated squarely around the pipe before final tightening. Do not exceed the rated 600-pound load capacity per hanger point.