Elements A500-125MB Cabinet Tab Pull Matte Black

Product Description

The ELEMENTS A500-125MB is a cabinet tab pull finished in matte black, designed for use on cabinet doors and drawers in residential and light commercial millwork applications. With an overall length of 1-1/4 inches and a projection of 1-1/2 inches, this pull provides a low-profile grip suited for overlay and inset cabinet styles. The matte black finish delivers a flat, non-reflective surface that resists fingerprints and complements contemporary and transitional cabinetry designs. This hardware is part of the Edgefield Collection and is typically installed by cabinetmakers, finish carpenters, and millwork contractors.

The A500-125MB tab pull is suited for residential kitchen, bathroom, and furniture cabinet applications where a compact, flush-mounted pull is preferred. Its 16 mm center-to-center hole spacing makes it compatible with standard pre-drilled cabinet door and drawer face frames. The 11/16-inch width keeps the profile narrow, making it appropriate for smaller cabinet doors, tip-out trays, and decorative drawers where a full bar pull would be oversized.

Key Features

• Overall length of 1-1/4 inches for compact, low-profile installations
• 16 mm center-to-center hole spacing for standard pre-drilled cabinet applications
• 1-1/2 inch projection provides adequate grip clearance
• 11/16-inch width suits narrow cabinet doors and drawer fronts
• Matte black finish for a flat, non-reflective appearance on contemporary cabinetry
• Part of the coordinated Edgefield Collection for consistent hardware styling across a project

Compatibility

Designed as a direct-mount cabinet tab pull for residential and light commercial cabinetry applications with 16 mm center-to-center pre-drilled mounting holes.

Installation Notes

Installation is typically performed by cabinetmakers or finish carpenters using a screwdriver or drill driver. Power down any under-cabinet lighting or connected systems before drilling new mounting holes. Verify that the cabinet face frame or drawer front is thick enough to accept the mounting screws without breakthrough. Use a template or jig to maintain consistent hole spacing across multiple pulls on a project.