Elements 625-128MS Cabinet Bar Pull 128mm Matte Silver

Product Description

The ELEMENTS 625-128MS is a square cabinet bar pull finished in matte silver, designed for installation on cabinet doors and drawers in residential and light commercial settings. With a 128 mm center-to-center hole spacing and an overall length of approximately 5.375 inches, this pull fits standard boring patterns used across most cabinetry. The square profile and matte silver finish give it a clean, contemporary look suited to modern and transitional cabinet designs. Cabinet installers, finish carpenters, and remodelers install this type of hardware as part of kitchen, bath, or built-in cabinet projects.

This bar pull is part of the Stanton collection from ELEMENTS and is intended for use on face-frame and frameless cabinetry alike. The 128 mm bore spacing is one of the most common intervals in residential cabinet hardware, making this pull a practical fit for new construction installs and replacement hardware projects. Its compact 0.375-inch width and 1.125-inch projection keep it close to the cabinet face while still providing a comfortable grip for daily use.

Key Features

• 128 mm center-to-center hole spacing matches standard cabinet boring patterns
• Overall length of 5.375 inches with a square bar profile
• Matte silver finish provides a low-sheen, contemporary appearance
• 1.125-inch projection keeps the pull close to the cabinet surface
• 0.375-inch width suits modern and transitional cabinet styles
• Part of the Stanton collection for coordinated hardware across a project

Compatibility

Designed as a direct-fit replacement or new-installation bar pull for cabinets with 128 mm center-to-center hole spacing, consistent with standard residential and light commercial cabinetry boring patterns.

Installation Notes

Cabinet bar pulls of this type are installed by finish carpenters, cabinet installers, or experienced DIYers using a drill, appropriate bit, and a hardware installation jig to ensure consistent hole placement. Power down any adjacent under-cabinet lighting circuits before drilling near electrical runs. Confirm hole spacing on the cabinet door or drawer front before drilling, as misaligned bores are not easily corrected. Mounting screws are typically sourced separately and should match the cabinet material thickness for proper pull seating.