Elements 560SN Cabinet Bar Pull 480mm Satin Nickel

Product Description

The ELEMENTS 560SN is a steel cabinet bar pull finished in satin nickel, designed for use on cabinet doors and drawers in residential and light commercial applications. Measuring 22-1/16 inches in overall length with a 480 mm (approximately 18-7/8 inches) center-to-center hole spacing, this pull features beveled ends and a 7/16-inch diameter bar profile. The 1-3/8-inch projection keeps hands clear of the cabinet surface during operation. Cabinetmakers, finish carpenters, and general contractors install this hardware during new construction and renovation projects.

This bar pull belongs to the Naples Collection and suits kitchen cabinets, bathroom vanities, built-ins, and furniture pieces where a clean, modern satin nickel finish is specified. The 480 mm center-to-center spacing accommodates wider drawer fronts and full-size cabinet doors commonly found in contemporary residential and commercial interiors. The steel construction provides durability in high-use environments.

Key Features

• 480 mm center-to-center hole spacing for wider cabinet and drawer applications
• 22-1/16-inch overall length with beveled ends for a finished appearance
• Satin nickel finish for a brushed, low-sheen look that resists fingerprints
• 7/16-inch diameter bar profile with 1-3/8-inch projection
• Steel construction for durability in daily-use cabinetry
• Part of the Naples Collection for coordinated hardware specification

Compatibility

Designed as a standard bar pull replacement or new-installation hardware for cabinet doors and drawers with 480 mm center-to-center hole spacing.

Installation Notes

Installation requires a drill and appropriate bit to bore mounting holes at 480 mm center-to-center if not pre-drilled. Mounting hardware such as machine screws is typically included or sourced separately to match cabinet door or drawer thickness. Power down any adjacent electrical components before drilling into built-in cabinetry. Verify hole alignment with a template before drilling to avoid surface damage.