Electro Hardware P593M09F16-1032 Hex Standoff 10-32

Product Description

The ELECTRO HARDWARE P593M09F16-1032 is a female hex circuit board standoff designed to create measured spacing between PCBs, panels, and mounting surfaces in electronic assemblies. This fastener features a 10-32 female thread, an overall length of 1.5 inches, and a 0.25-inch width across flats. Constructed from 18-8 and Grade 303 stainless steel with a bright anodized finish, it meets the QQ-S-763 fastener standard. This standoff is installed by electronics assemblers, field technicians, and trade professionals mounting control boards in HVAC, electrical, and industrial enclosures.

This standoff is suited for residential and commercial applications where a threaded female hex spacer is required to stack or elevate circuit boards within enclosures or on panel surfaces. Typical use cases include control board mounting in HVAC equipment, industrial control panels, and electrical enclosures where consistent, vibration-resistant board spacing is critical. The hex body allows standard wrench engagement for secure, repeatable installation torque without slipping.

Key Features

• Female 10-32 thread accepts standard machine screws for board-to-board or board-to-panel stacking
• 1.5-inch overall length provides reliable standoff clearance for component spacing
• Hex body (0.25 inches across flats) allows wrench engagement for secure installation
• 18-8 and Grade 303 stainless steel construction resists corrosion in damp or outdoor enclosures
• Bright anodized finish meets QQ-S-763 fastener standard
• Length tolerance of -0.005 to 0.005 inches ensures dimensional consistency across assemblies

Compatibility

Designed as a standard female hex standoff for use with 10-32 machine screws in circuit board mounting applications across HVAC control boards, electrical enclosures, and industrial panel assemblies.

Installation Notes

Installation is performed by electronics assemblers or licensed technicians working on control board assemblies. Always power down and de-energize the enclosure or panel before installing or replacing standoffs near live circuitry. Use an appropriately sized open-end or box wrench on the hex body to seat the standoff without over-tightening. Follow applicable NEC guidelines when mounting control boards within electrical enclosures.