Electro Hardware MP1027M06F16M4 Female Hex Standoff M4x0.7

Product Description

The ELECTRO HARDWARE MP1027M06F16M4 is a female hex circuit board standoff machined from aluminum alloy to metric M4x0.7 threading. The standoff measures 14 mm (approximately 0.551 inches) overall length with a fully threaded interior bore at 14 mm thread depth, providing full engagement across the entire body. The hex body measures 6 mm (approximately 0.236 inches) width across flats, allowing a standard hex driver or wrench to install and torque the standoff without slipping. The plain, bright uncoated finish meets QQ-A-225A Comp 2 material standards for T3-grade aluminum. Electronics assemblers, PCB technicians, and hardware installers use this standoff to create precise, rigid spacing between a circuit board and a mounting surface or between stacked boards.

This standoff is suited for use in electronic enclosures, control panel assemblies, industrial equipment, and any application requiring a fixed, threaded female mount point for an M4 fastener. It is appropriate for both prototype and production PCB assembly work where consistent board-to-surface clearance is required. The all-metric dimensioning makes it a direct fit for metric-spec assemblies. Minimum order quantity is 5 pieces, sold individually per package.

Key Features

• M4x0.7 female threading fully through the 14 mm body length
• Hex body profile at 6 mm width across flats for wrench-driven installation
• T3-grade aluminum construction — lightweight and corrosion resistant
• Plain bright finish compliant with QQ-A-225A Comp 2 standard
• Fully threaded bore allows fastener engagement at any depth up to 14 mm
• Metric dimensioning for direct use in metric-spec PCB and enclosure assemblies

Compatibility

Designed for use with M4x0.7 metric fasteners in circuit board mounting applications requiring aluminum female hex standoffs. Verify panel hole diameter and mating screw thread pitch before installation.

Installation Notes

Installation is performed by electronics assemblers or hardware technicians using a hex wrench or nut driver sized to 6 mm across flats. Always de-energize the assembly and discharge any stored capacitance before working on circuit boards. Avoid over-torquing aluminum standoffs, as the material is softer than steel and threads can strip under excessive force. Confirm mating screw length does not exceed the 14 mm thread depth to prevent bottoming out.