Electro Hardware MM1701M06MSC-1 Hex Standoff 10-32 1/8 in

Product Description

The ELECTRO HARDWARE MM1701M06MSC-1 is a male-male hex circuit board standoff used to mount and space printed circuit boards within electronic enclosures and control assemblies. Machined from aluminum to material grade T3 and finished with a clear coating, this standoff meets the QQ-A-225A Comp 2 fastener standard. The overall length is 0.125 inches with a body length of 0.125 inches and a hex width across flats of 0.375 inches. Both threaded ends are sized 10-32. HVAC technicians, electricians, and electronics assembly professionals install these fasteners during control board mounting and panel assembly work.

This standoff is suited for use in low-voltage control panels, HVAC circuit board assemblies, electrical enclosures, and other applications requiring rigid, non-conductive-free board spacing. The hex body shape allows installation and removal with standard hex drivers or open-end wrenches. Its compact 0.125-inch overall length makes it appropriate for tight board clearance situations where minimal stack height is required. Single-piece packaging supports one-for-one replacement in field service or bench repair scenarios.

Key Features

• Male-male threaded configuration with 10-32 thread size on both ends
• Hex body shape allows tool engagement with standard hex drivers or wrenches
• Aluminum construction with T3 material grade for lightweight, corrosion-resistant performance
• Clear finish per QQ-A-225A Comp 2 fastener standard
• Overall length of 0.125 inches with a width across flats of 0.375 inches
• Length tolerance of -0.005 to 0.005 inches for consistent fit in precision assemblies

Compatibility

Designed as a standard 10-32 male-male hex standoff for use in circuit board mounting applications where a 0.125-inch overall length and 0.375-inch hex width are specified.

Installation Notes

Installation is typically performed by electronics assembly technicians or licensed electricians during control board mounting or panel build-out. De-energize all circuits and discharge any stored voltage before working on circuit board assemblies. Use a properly sized hex driver or open-end wrench to avoid rounding the hex flats. Follow applicable NEC guidelines and equipment manufacturer torque requirements when securing standoffs in control enclosures.