Electro Hardware MM1341M09-MSC Hex Board Standoff 6-32

Product Description

The ELECTRO HARDWARE MM1341M09-MSC is a male-male hex circuit board standoff designed to mount and space printed circuit boards in electronic assemblies. Threaded 6-32 on both ends, the standoff accepts a mating fastener on each side to stack or elevate boards at a fixed distance. The overall length is 0.75 inches, the body is hex-shaped with a width across flats of 0.1875 inches, and the part is machined from Grade 18-8 303 stainless steel with a passivated finish. Electricians, electronics assemblers, and panel-build technicians install these standoffs when building control panels, drive enclosures, or relay boards that require secure PCB mounting with a defined standoff height.

This standoff is suited for indoor electronic assemblies where corrosion resistance and dimensional consistency matter. Typical applications include HVAC control board mounting, electrical panel sub-assemblies, and industrial electronics enclosures. The 6-32 thread size is one of the most common in circuit board hardware, making this standoff a direct-fit replacement for worn or missing hardware in existing assemblies. Because it is sold individually, it is practical for field repair work where only one or a few fasteners need replacement.

Key Features

• Male-male 6-32 threaded on both ends for board-to-board or board-to-chassis stacking
• Hex body profile at 0.1875 inches width across flats allows torque with a standard hex wrench or nut driver
• Overall length of 0.75 inches provides consistent board spacing in tight enclosures
• Grade 18-8 303 stainless steel construction resists corrosion in humid or mildly corrosive environments
• Passivated finish per QQ-S-763 standard removes free iron from the surface and improves corrosion resistance
• Sold as a single piece, suitable for single-unit field repairs

Compatibility

Designed as a standard 6-32 male-male hex standoff for use in any printed circuit board assembly or enclosure that accepts 6-32 threaded hardware with a 0.75-inch standoff height.

Installation Notes

Installation is performed by electronics technicians or licensed electricians during panel assembly or board replacement. De-energize all circuits before working inside any control panel or enclosure. Use an appropriately sized hex wrench or nut driver matching the 0.1875-inch width across flats to seat and torque the standoff without rounding the hex body. Do not over-torque stainless steel fasteners into aluminum or thermoplastic standoff bosses, as galling or thread damage may result.