Electro Hardware EBSO-632-14ZI Hex Board Standoff 6-32

Product Description

The ELECTRO HARDWARE EBSO-632-14ZI is a female hex circuit board standoff designed for mounting printed circuit boards to enclosures, panels, or secondary boards at a fixed, repeatable height. The standoff uses a self-clinching installation method with a blind hole thread, allowing it to press into a prepared panel and accept a mating screw from above. The 6-32 female thread and 0.437-inch overall length make it well-suited for standard board-mounting applications where precise spacing and reliable thread engagement are required. Finished in zinc over steel, it offers corrosion resistance appropriate for indoor electrical enclosures. Sold in packages of 25 units.

This standoff is used in residential and commercial electrical, control panel, and HVAC electronics applications wherever circuit boards must be securely mounted and electrically or mechanically isolated from the mounting surface. Technicians installing control boards in furnace air handlers, electrical enclosures, or equipment panels commonly use this type of hardware. The hex body profile allows for wrench engagement during removal or repositioning.

Key Features

• 6-32 female thread with self-clinching blind hole fastening method for secure panel installation
• 0.437-inch overall length provides consistent board standoff height
• 1/4-inch width across flats on hex body allows wrench-driven installation and removal
• Steel construction with zinc finish for corrosion resistance in indoor enclosure environments
• Inch measurement system for compatibility with standard North American fastener tooling
• Package quantity of 25 units per pack, minimum order of 1 package

Compatibility

Designed as an OEM-style replacement or service hardware for circuit board mounting applications requiring a 6-32 female hex standoff with a 0.437-inch overall length and self-clinching installation.

Installation Notes

Installation is performed by pressing the standoff into a properly sized punched or drilled hole in the mounting panel using an arbor press or punch tool — do not hammer directly onto the standoff body. Always de-energize and lock out the equipment before working inside any electrical enclosure or control panel. A wrench sized to 1/4-inch across flats may be used for alignment or removal. Follow applicable NEC or equipment manufacturer guidelines for control board mounting clearances.