Eklind 18228 Long Arm Ball End Hex Key 7mm

Product Description

The EKLIND 18228 is a long-arm hex key with a ball end tip and L-handle design, built for fastening and loosening standard hex fasteners in tight or angled spaces. The ball end allows up to 30 degrees of off-axis access, letting technicians drive fasteners at an angle without removing the key. Constructed from alloy steel, this hex key delivers the strength needed for repetitive service work. With an overall length of 7.5 inches, the long arm provides additional torque leverage compared to standard-arm versions. It is suited for HVAC equipment assembly, panel work, electrical enclosures, and general mechanical service tasks where hex fasteners are common.

This hex key is used across residential and commercial service applications wherever 7mm standard hex fasteners are encountered. HVAC technicians, electricians, plumbers, and general mechanical trades keep long-arm hex keys on hand for equipment access panels, set screws, motor mounts, and bracket hardware. The L-handle configuration makes it easy to switch between the short arm for high-torque driving and the long arm for speed and reach in open spaces.

Key Features

• Ball end tip allows up to 30 degrees of off-axis fastener access
• Long arm design at 7.5 inches overall length provides extended reach and torque leverage
• L-handle configuration supports both high-torque and high-speed driving
• Alloy steel construction for durability in frequent service use
• Fits 7mm standard hex fasteners

Compatibility

Designed as a standard replacement or service hex key for applications requiring a 7mm long-arm L-handle ball-end driver with standard hex fastener compatibility.

Installation Notes

No installation is required for this hand tool. Before servicing any equipment, power down electrical systems or shut off gas and water supplies as appropriate to the trade application. Use the short arm end when maximum torque is needed and the long arm end for faster driving in accessible locations. Do not apply excessive side force to the ball end, as this can reduce the tool lifespan over time.