Eklind 103220 Ball End Hex Impact Bit Holder 5/16 in

Product Description

The EKLIND 103220 is a ball end hex power impact screwdriver bit holder designed for use with 1/4 inch drive impact tools. Built from alloy steel, this bit holder measures 3 inches in overall length and accepts a 5/16 inch hex ball end fastener interface. The ball end geometry allows for driving at moderate off-axis angles without losing engagement, which is useful in confined or angled installation scenarios. It is sold as a single piece and is intended for trade professionals working with impact drivers in mechanical, HVAC, electrical, or general construction applications where hex fasteners are common.

This bit holder is suited for residential and light commercial work wherever 1/4 inch drive impact screwdrivers are used to drive 5/16 inch hex fasteners. Typical applications include equipment panel fastening, ductwork assembly, electrical enclosure work, and general mechanical assembly tasks. The 3 inch length provides added reach in recessed or partially obstructed fastener locations. Its alloy steel construction handles the rotational and impact stress generated by power impact drivers in regular field use.

Key Features

• Ball end hex tip allows driving at off-axis angles for access in tight spaces
• 1/4 inch drive shank compatible with standard impact drivers and bit holders
• 5/16 inch hex size for common fastener applications in mechanical and construction trades
• 3 inch overall length provides added reach over standard-length bits
• Alloy steel construction rated for power impact tool use
• Non-magnetic tip design

Compatibility

Designed as an OEM-style replacement for MSC 98558109. Compatible with 1/4 inch drive power impact screwdrivers and impact bit extension holders accepting standard hex shank bits.

Installation Notes

Install and remove bit holders only when the impact driver is powered off and the trigger is locked out. Confirm the shank is fully seated in the tool chuck before applying load. Inspect the bit tip for wear or rounding before each use, as a worn ball end can slip under impact torque and damage fastener heads. No special tools or codes are required for installation of the bit itself.