Ecm Industries Llc PPC-1525 White Plastic Cable Clamp 18 Pack

Product Description

The ECM INDUSTRIES LLC PPC-1525 is a white plastic 1-hole cable clamp designed for securing and organizing cables, conduit, or tubing in electrical, HVAC, and plumbing installations. Sold in an 18-piece bag, each clamp features a 1/4 inch inside diameter opening suitable for small-diameter wire bundles or tubing runs. These lightweight plastic clamps provide a clean, low-profile fastening point and are commonly used to route conductors neatly along framing, panels, or mechanical equipment enclosures. Licensed electricians, HVAC technicians, and plumbing installers reach for clamps like these during rough-in and finish work wherever cable management and code-compliant securing intervals are required.

These clamps are well-suited for residential and light commercial applications where small-diameter cables or tubing need to be anchored to a surface at regular intervals. Typical use cases include securing low-voltage wiring, thermostat cable, small refrigerant line insulation, or plumbing supply tubing. The white finish blends into standard drywall and trim environments. The single-hole design allows for straightforward nail or screw mounting directly through the clamp body.

Key Features

• 1/4 inch inside diameter fits small-diameter cables and tubing
• Single-hole mounting design for fast nail or screw installation
• White plastic construction resists corrosion and blends with interior finishes
• Sold in an 18-piece bag for multi-point runs in a single package
• Lightweight at 0.64 pounds per bag, easy to carry on the job

Compatibility

Designed as a general-purpose cable and tubing clamp for residential and light commercial installations where a 1/4 inch inside diameter single-hole plastic clamp is required.

Installation Notes

Installation is typically performed by licensed electricians, HVAC technicians, or plumbers during rough-in or trim-out stages. De-energize all circuits before securing wiring harnesses or cable bundles. Clamps should be fastened at intervals consistent with applicable NEC or local mechanical code requirements for the cable or tubing type being supported. Avoid over-tightening the mounting fastener, as excess force can crack the plastic clamp body.