Ecm Industries Llc 20-143F Female Disconnect 16-14 Awg 600V

Product Description

The ECM INDUSTRIES LLC 20-143F is a vinyl-insulated female disconnect terminal sold in a 20-piece pack. It accepts 16-14 AWG wire and is rated for up to 600 volts maximum, making it suitable for a wide range of low-voltage and line-voltage wiring applications. The vinyl barrel provides insulation and strain relief at the connection point. This terminal is UL approved and carries a temperature rating of 167 degrees F (75 degrees C), confirming its suitability for use in HVAC control wiring, panel wiring, and general electrical assembly work performed by licensed electricians and HVAC technicians.

These disconnects are used in residential and light commercial applications where a reliable, removable push-on connection is needed. Common install scenarios include HVAC control board wiring, relay and contactor pigtail connections, and electrical panel harness assembly. The 0.250-inch tab size is a standard fit for many spade terminals found on contactors, relays, and control components. The 20-pack quantity suits service technicians who carry stock for field repairs and small-run panel work.

Key Features

• Vinyl insulated barrel provides electrical insulation and wire grip at the crimp zone
• Accepts 16-14 AWG wire for mid-range conductor sizing common in control and power circuits
• Rated at 600 volts maximum for broad application coverage
• Temperature rated to 167 degrees F (75 degrees C) for use in heated equipment enclosures
• 0.250-inch tab size fits standard spade terminals on contactors, relays, and control boards
• UL approved construction

Compatibility

Designed as a standard 0.250-inch female push-on disconnect for use with 16-14 AWG wire in HVAC, electrical, and light commercial control wiring applications.

Installation Notes

Installation should be performed by a qualified electrician or licensed HVAC technician in accordance with NEC requirements. De-energize and lock out the circuit before terminating or removing any disconnect terminal. Use a proper ratcheting crimp tool sized for 16-14 AWG terminals to achieve a secure, gas-tight crimp. Do not attempt to solder over a crimped connection or reuse a terminal that has been pulled from a tab.