Eagle Cutting Tool SDS4350-6875-12-D Masonry Drill Bit

Product Description

The EAGLE CUTTING TOOL SDS4350-6875-12-D is a carbide-tipped SDS masonry drill bit designed for rotary hammer drilling into concrete, block, brick, and similar masonry substrates. The bit measures 11/16 inches in diameter with an overall length of 12-3/4 inches and features a delta tip geometry that improves penetration rate and helps clear debris from the bore hole. At 0.64 pounds, it is light enough for extended overhead or horizontal drilling tasks. Contractors, electricians, plumbers, and HVAC technicians reach for this bit when core anchor holes or conduit pass-throughs are needed in masonry construction.

This bit is suited for residential and light commercial applications where SDS-compatible rotary hammers are the standard tool of choice. Common uses include drilling anchor bolt holes, conduit penetrations, hanger sleeves, and equipment mounting holes through poured concrete walls, CMU block, and brick. The 12-3/4 inch length provides the working depth needed to clear typical wall assemblies and reach reinforcing layers without an extension.

Key Features

• Carbide-tipped cutting head resists wear in abrasive masonry materials
• Delta tip geometry promotes aggressive penetration and efficient debris ejection
• SDS shank provides positive engagement with SDS rotary hammer chucks
• 11/16 inch diameter suits common anchor and conduit hole requirements
• 12-3/4 inch overall length accommodates deep penetrations through thick wall assemblies
• Lightweight at 0.64 pounds for reduced fatigue during extended drilling

Compatibility

Designed for use with standard SDS rotary hammers. No specific compatible tool models or replaced part numbers were provided in the product data.

Installation Notes

Installation should be performed by a qualified tradesperson following applicable codes including NEC, IPC, or IFGC requirements for penetrations and anchor placement. Wear appropriate eye and respiratory protection when drilling into masonry, as carbide-tip bits generate fine silica dust. Ensure the rotary hammer is powered off and the battery or power source is disconnected when inserting or removing the bit from the chuck. Do not use this bit in drill-only mode on an SDS hammer; always engage the rotation-plus-hammer setting for masonry applications.

Technical Specifications

• Shank Type: SDS
• Tip Type: Carbide Tip Delta
• Diameter: 11/16 inches
• Overall Length: 12-3/4 inches
• Weight: 0.64 pounds
• Minimum Order Quantity: 1

Standard Information

• Brand: EAGLE CUTTING TOOL
• Manufacturer Part Number: SDS4350-6875-12-D