Eagle Cutting Tool SDS4350-3750-6-D Sds Masonry Drill Bit

Product Description

The EAGLE CUTTING TOOL SDS4350-3750-6-D is an SDS-shank masonry drill bit designed for rotary hammer drilling into concrete, block, brick, and other masonry substrates. The bit measures 3/8 inch in diameter with an overall length of 6-5/8 inches, providing sufficient reach for anchor bolt holes, conduit penetrations, and similar trade applications. The Delta tip geometry is engineered to promote aggressive material removal while reducing heat buildup during extended drilling cycles. This bit is sized for common rotary hammer chucks used by electricians, plumbers, and general contractors on commercial and residential job sites.

This SDS masonry drill bit is suited for light to medium rotary hammer work where a 3/8-inch diameter hole is required. Typical applications include setting concrete anchors for conduit straps, drilling through block or poured concrete for pipe sleeves, and penetrating masonry walls for low-voltage wiring runs. The 6-5/8-inch overall length accommodates penetrations through standard CMU block and thick concrete slabs without requiring an extension.

Key Features

• 3/8-inch diameter with 6-5/8-inch overall length for reach in typical masonry penetrations
• Delta tip geometry for efficient material removal in rotary hammer applications
• SDS shank provides positive chuck engagement and efficient hammer energy transfer
• Compatible with standard SDS rotary hammer chucks across major tool brands
• Sized for anchor bolt and conduit sleeve work in concrete and masonry

Compatibility

Designed as a standard SDS-shank masonry drill bit for use with SDS rotary hammers requiring a 3/8-inch bit in concrete, brick, block, and similar masonry materials.

Installation Notes

Install this bit into a compatible SDS rotary hammer chuck; confirm the shank seats and locks fully before drilling. Wear appropriate eye and respiratory protection when drilling masonry. Follow OSHA silica dust control guidelines when drilling concrete or block. Inspect the carbide tip for wear or damage before each use and replace the bit if the tip shows cracking or excessive dulling.

Technical Specifications

• Shank Type: SDS
• Drill Diameter: 3/8 inch
• Overall Length (OAL): 6-5/8 inches
• Tip Geometry: Delta
• Application: Masonry, concrete, brick, block
• Weight: 0.28 pounds
• Minimum Order Quantity: 1

Standard Information

• Brand: EAGLE CUTTING TOOL
• Manufacturer Part Number: SDS4350-3750-6-D