Eagle Cutting Tool SDS4350-2812-8-D Sds Masonry Drill

Product Description

The EAGLE CUTTING TOOL SDS4350-2812-8-D is an SDS-shank masonry drill bit designed for rotary hammer applications in concrete, block, brick, and other masonry substrates. The bit measures 9/32 inches in diameter with an overall length (OAL) of 8-5/8 inches, providing the reach needed for deeper anchor and fastener holes in structural and finish masonry work. Weighing 0.14 pounds, it is a lightweight tool that transfers full impact energy to the cutting face. Licensed electricians, plumbers, HVAC technicians, and general contractors routinely use bits of this type when setting anchors, conduit supports, pipe hangers, and equipment mounting hardware in concrete or masonry walls.

This bit is suited for residential and light commercial masonry drilling tasks where an SDS-plus rotary hammer is the tool of choice. Typical applications include setting drop-in anchors, threaded rod inserts, and sleeve anchors in poured concrete or CMU block. The 8-5/8-inch OAL allows drilling through thicker walls or reaching past obstructions without an extension. It is a standard single-unit purchase, making it practical to stock individually for service van inventory or job-site replenishment.

Key Features

• SDS shank for positive lock and quick-change compatibility with SDS-plus rotary hammers
• 9/32-inch diameter sized for common anchor and fastener pilot holes in masonry
• 8-5/8-inch overall length provides extended reach for deeper or through-wall drilling
• Lightweight at 0.14 pounds for reduced fatigue during overhead or extended use
• Delta tip geometry indicated in product designation for aggressive masonry penetration

Compatibility

Designed as an OEM-style replacement and standard stock bit for use with SDS-plus rotary hammers rated for masonry drilling applications.

Installation Notes

Installation should be performed by a qualified tradesperson following applicable safety codes and job-site requirements. Verify the rotary hammer accepts SDS-plus shanks before inserting the bit, and confirm the chuck is fully locked before operation. When drilling near existing utilities or rebar, use a scanning tool to locate embedded hazards prior to drilling. Wear appropriate eye and hearing protection, and follow OSHA and manufacturer guidelines for rotary hammer operation.

Technical Specifications

• Shank Type: SDS
• Drill Diameter: 9/32 inches
• Overall Length (OAL): 8-5/8 inches
• Weight: 0.14 pounds
• Application: Masonry
• Minimum Order Quantity: 1

Standard Information

• Brand: EAGLE CUTTING TOOL
• Manufacturer Part Number: SDS4350-2812-8-D