Eagle Cutting Tool SB-WB1.250 Spade Bit 1.25x6 in

Product Description

The EAGLE CUTTING TOOL SB-WB1.250 is a 1.25-inch wide by 6-inch long spade bit designed for boring clean, flat-bottomed holes through wood framing, sheathing, and structural members. The extended 6-inch length gives tradespeople the reach needed to drill through thick assemblies or double-stud walls in a single pass. At 0.14 pounds, it is lightweight enough for prolonged use without added fatigue. This bit is a standard tool for electricians, plumbers, and HVAC installers who need to route conduit, pipe, or duct runs through wood framing during rough-in work.

The SB-WB1.250 is suited for residential and light commercial applications where 1.25-inch diameter holes are required through lumber, engineered wood, or OSB. Common install scenarios include drilling through wall plates and floor joists to pass electrical conduit, PEX tubing, or low-voltage wiring. The 6-inch shaft length makes it particularly useful when working in tight framing bays where a standard-length bit cannot reach far enough to complete the bore.

Key Features

• 1.25-inch cutting diameter for routing conduit, pipe, and wiring through framing
• 6-inch overall length provides extended reach through thick or doubled framing members
• Lightweight at 0.14 pounds for reduced fatigue during repetitive drilling
• Flat spade profile creates clean, defined holes in wood substrates
• Compatible with standard drill chuck sizes used by electricians, plumbers, and HVAC installers

Compatibility

Designed for use with standard corded and cordless drills and right-angle drills equipped with a keyed or keyless chuck. Suitable for drilling through softwood, hardwood, OSB, and plywood in residential and light commercial framing applications.

Installation Notes

Install this bit into the drill chuck and tighten securely before use. Electricians and plumbers should confirm that local codes such as NEC and IPC specify minimum clearance requirements for holes bored through structural members. Avoid drilling holes closer to the edge of a joist or stud than code or engineering specifications allow. Always verify there are no hidden utilities on the opposite side of the member before beginning a bore.

Technical Specifications

• Cutting Diameter: 1.25 inches
• Overall Length: 6 inches
• Weight: 0.14 pounds
• Bit Type: Spade / Wood Boring

Standard Information

• Brand: EAGLE CUTTING TOOL
• Manufacturer Part Number: SB-WB1.250