Eagle Cutting Tool RBCS-6250-OP Sds Plus Rebar Cutter

Product Description

The EAGLE CUTTING TOOL RBCS-6250-OP is an SDS Plus shank rebar cutter designed for cutting through reinforcing bar in concrete construction and demolition applications. Built for use with SDS Plus rotary hammer drills, this cutter delivers the torque and impact energy needed to shear rebar cleanly without requiring a separate cutting tool. At 4.87 pounds, it is a solid, purpose-built accessory suited for concrete formwork removal, retrofit anchor work, and rebar trimming on active job sites. Licensed electricians, structural ironworkers, concrete contractors, and general construction crews are the primary users of this tool.

This rebar cutter is used in residential and commercial concrete construction where embedded rebar must be cut flush or trimmed to length. Typical applications include slab demolition, foundation work, post-tension slab repair, and concrete cutting operations where a dedicated rebar cutter is required. The SDS Plus shank interface ensures compatibility with standard SDS Plus rotary hammers, which are common on most commercial and residential job sites. The single-piece configuration means no assembly is required before use.

Key Features

• SDS Plus shank interfaces directly with SDS Plus rotary hammer drills
• Designed to cut 0.625 inch diameter rebar
• Single-piece construction requires no pre-assembly
• Weighs 4.87 pounds for a solid, durable build
• Purpose-built for concrete construction and demolition applications

Compatibility

Designed for use with SDS Plus rotary hammer drills capable of driving rebar cutting attachments. Intended for cutting 0.625 inch diameter reinforcing bar in concrete construction applications.

Installation Notes

Installation and operation should be performed by qualified construction professionals familiar with SDS Plus tooling and rebar cutting procedures. Before attaching or removing the cutter, ensure the rotary hammer is powered off and disconnected from its power source. Verify that the SDS Plus chuck is clean and free of debris before inserting the shank. Always wear appropriate personal protective equipment including eye protection and gloves when cutting rebar.

Technical Specifications

• Shank Type: SDS Plus
• Cutting Diameter: 0.625 inches
• Weight: 4.87 pounds
• Minimum Order Quantity: 1

Standard Information

• Brand: EAGLE CUTTING TOOL
• Manufacturer Part Number: RBCS-6250-OP