Eagle Cutting Tool A712-132-I Hss Aircraft Drill Bit

Product Description

The EAGLE CUTTING TOOL A712-132-I is a high-speed steel (HSS) aircraft-length drill bit ground with a 135-degree split-point tip. The extended 12-inch overall length (OAL) is designed to reach deep or awkward drilling locations that standard-length bits cannot access. At 3/32 inch in diameter, this bit handles precision holes in metal, aluminum, and composite materials. The 135-degree split point reduces walking on entry, eliminates the need for a center punch on most surfaces, and requires less feed pressure than conventional 118-degree bits. Licensed contractors, aircraft maintenance technicians, and sheet-metal workers keep this bit on hand for demanding structural and fabrication work.

Aircraft-length drill bits serve applications where reach is critical — drilling through structural members, elongated assemblies, or stacked material where a jobber-length bit falls short. This bit is well suited for HVAC duct fabrication, electrical rough-in through deep framing, plumbing penetrations, and general sheet-metal trade work. The HSS construction handles ferrous and non-ferrous metals at standard drill press or hand-drill speeds without specialty coatings required for most common trade materials.

Key Features

• 135-degree split-point tip reduces walking and lowers feed pressure on metal entry
• 12-inch overall length provides extended reach for deep or confined drilling locations
• High-speed steel (HSS) construction withstands heat generated in metal drilling applications
• 3/32-inch diameter suited for precision fastener pilot holes and small-diameter penetrations
• Aircraft-length designation meets dimensional standards for extended-reach trade work

Compatibility

Designed as a standard shank aircraft-length drill bit compatible with 3/8-inch and larger keyed or keyless drill chucks used in hand drills, right-angle drills, and drill presses.

Installation Notes

Install this bit in a properly sized chuck and confirm it is fully seated and tightened before operation. Secure workpieces firmly to prevent movement during drilling. Use appropriate cutting fluid or lubricant when drilling ferrous metals to extend bit life and reduce heat buildup. Inspect the cutting edges before each use and replace the bit if chipping or dulling is present.

Technical Specifications

• Diameter: 3/32 inch
• Overall Length (OAL): 12 inches
• Point Angle: 135 degrees
• Point Type: Split Point
• Material: High-Speed Steel (HSS)
• Weight: 0.07 pounds
• Minimum Order Quantity: 1

Standard Information

• Brand: EAGLE CUTTING TOOL
• Manufacturer Part Number: A712-132-I