Dynabrade 13202 Finishing Sander 0.7 Hp 3400 Rpm

Product Description

The DYNABRADE 13202 is a pneumatic finishing sander designed for surface finishing, smoothing, and final-pass sanding on metal, wood, and composite materials. Running at 3,400 RPM and driven by a 0.7 HP air motor, this tool delivers consistent, controlled material removal suited to production and fabrication environments. It requires a 1/4 NPT air inlet and consumes 34.5 CFM at 6.21 bar (90 psi) operating pressure. At 2.14 pounds, it is light enough for extended overhead or detail work. Licensed tradespeople and production finishers in industrial and manufacturing settings are the primary users.

The 13202 is suited for finish sanding operations in automotive body shops, metal fabrication shops, woodworking facilities, and general industrial production lines. Its pneumatic drive makes it compatible with standard shop air systems where a stable supply of compressed air at the rated pressure and flow is maintained. The 14.8-inch overall length provides reach for flat panel and contoured surface work without operator fatigue over long runs.

Key Features

• 0.7 HP air motor delivers consistent power at 3,400 RPM for controlled finish sanding
• 34.5 CFM air consumption — verify compressor capacity before use in high-demand environments
• 6.21 bar operating pressure for reliable, repeatable sanding performance
• 1/4 NPT inlet fitting compatible with standard shop air supply lines
• 14.8-inch overall length supports reach and control on flat and contoured surfaces
• Lightweight at 2.14 pounds for reduced operator fatigue during extended use

Compatibility

Designed as an OEM-style pneumatic finishing sander for use with standard compressed air systems supplying a minimum of 34.5 CFM at 6.21 bar through a 1/4 NPT connection.

Installation Notes

Installation and operation should be performed by qualified personnel familiar with pneumatic tool safety and applicable OSHA and ANSI standards for abrasive tools. Before connecting to an air supply, verify that the line pressure does not exceed the rated operating pressure of 6.21 bar and that the compressor output meets the 34.5 CFM consumption requirement. Always depressurize the air line before attaching or removing the sander from the supply hose. Inspect the abrasive pad and backing plate for wear or damage before each use.