

Ships same day if ordered by 12 pm
Manufacturer pricing rules prevent us from advertising our discount — no account or email required to see it.
Secure Payments
Easy Returns
Expert Advice
Fast Shipping
The DIVERSITECH gv14 is a vinyl grommet designed to protect cables and wires routed through sharp-edged cutouts in sheet metal panels, enclosures, and equipment housings. At 7/8 inch diameter, the grommet fits over the hole edge and creates a smooth, protected pass-through surface that prevents insulation damage and chafing on conductors. This pack contains 4 grommets. HVAC technicians, electricians, and plumbers use these when routing control wiring, refrigerant tubing insulation sleeves, or low-voltage cables through metal cabinets and equipment panels.
The gv14 grommets are suited for both ducted and ductless system installations. Common applications include routing thermostat wire, line-voltage conductors, or communication cables through the thin-gauge sheet metal used in air handlers, condenser units, furnace cabinets, and electrical enclosures. The 7/8 inch size fits standard knockout or drilled holes of that diameter commonly found in residential and light commercial HVAC equipment and electrical panels.
Designed for use with both ducted and ductless HVAC equipment, as well as general electrical enclosures and panels requiring 7/8 inch grommets for cable and wire pass-through protection.
Power down or de-energize any equipment before routing cables through panel cutouts. Press the grommet firmly into the hole until the flange seats flush against both sides of the panel material. No special tools are required for installation. Ensure the grommet is fully seated before pulling cables through to maintain edge protection.
Thanks for subscribing!
This email has been registered!