Dial Corporation DIA16652 Touch-free Foam Soap Dispenser

Product Description

The DIAL CORPORATION DIA16652 is a touch-free, wall-mount foam soap dispenser designed for commercial and institutional washroom installations. Built from ivory ABS plastic with a clear side-panel strip, it holds 1 liter of foam soap and lets facility staff check fill levels without removing the unit. Smart-Sensor Technology detects hand presence and stops dispensing the moment hands are withdrawn, reducing waste. Four D alkaline batteries power the unit, eliminating the need for electrical wiring. The Clean Tip pump minimizes drips between uses, cutting down on surface residue and housekeeping time. The dispenser is rated for over 90,000 activations, making it a practical choice for high-traffic restrooms.

This dispenser is suited for commercial restrooms, office buildings, healthcare facilities, schools, and foodservice back-of-house areas. It is installed by facility maintenance staff or janitorial contractors. The adjustable shot-per-activation setting — one, two, or three shots — allows managers to calibrate product output based on traffic volume and soap viscosity, helping extend refill intervals in busy environments.

Key Features

• Smart-Sensor Technology stops dispensing immediately when hands are removed, reducing over-dispensing
• Clean Tip pump design minimizes drip and residue between activations
• Adjustable output: one, two, or three shots per activation for product-usage control
• Clear side-panel strip allows fill-level checks without opening the housing
• Battery-powered operation using four D alkaline batteries — no electrical rough-in required
• Rated for over 90,000 activations, supporting extended service intervals in high-traffic locations

Compatibility

Designed for use with compatible 1-liter foam soap refill cartridges intended for the FIT touch-free dispenser platform. Verify refill cartridge compatibility with the DIA16652 before ordering consumables.

Installation Notes

Installation is typically performed by facility maintenance personnel or a janitorial contractor. Mount the dispenser to a wall surface at the appropriate height per ADA guidelines and facility standards using the integrated mounting hardware. Insert four D alkaline batteries before loading the soap cartridge and activating the sensor. Power down the unit by removing batteries before performing any internal service or cartridge replacement.