Dewalt DWAX101IR Impact Ready Screwdriver Bit Set 31 Pc

Product Description

The DEWALT DWAX101IR is a 31-piece impact-ready insert bit set designed for use with 1/4-inch hex drive impact drivers and power screwdrivers. The set covers the most common drive types on a jobsite: Phillips, slotted, Torx, and hex. Each bit is 1 inch in overall length and built from steel for resistance to the high-torque, high-cycle demands of impact tool use. The bits arrive in a plastic storage case that keeps the set organized and protects against loss between uses. Licensed electricians, plumbers, HVAC technicians, and general contractors will find this set covers the fastener variety typical of trade rough-in and finish work.

This set is suited for residential and commercial trade applications where a technician needs to drive a wide range of fastener types without swapping between multiple bit cases. The included Phillips sizes span No. 1 through No. 3, Torx sizes cover T20 and T25, and the hex shank is 6 millimeters. These drive types align with the fastener profiles found in electrical enclosures, HVAC equipment panels, plumbing fixture hardware, and structural connections. The plastic storage case makes it practical for a tool bag or service van tray.

Key Features

• 31-piece set covering Phillips, slotted, Torx, and hex drive types in a single case
• Impact-ready construction handles the rotational stress of 1/4-inch hex drive impact drivers
• Steel bit material for durability under high-torque applications
• 1-inch insert bit length fits standard bit holders and quick-change chucks
• Plastic storage case organizes all 31 pieces and protects bits during transport
• Phillips sizes No. 1 through No. 3 and Torx T20 and T25 included for broad fastener coverage

Compatibility

Designed for use with 1/4-inch hex drive impact drivers, drills, and power screwdrivers that accept standard 1-inch insert bits.

Installation Notes

Insert bits should be seated fully into the tool chuck or bit holder before driving to prevent cam-out or bit ejection. Power down the tool before changing bits. When working inside electrical panels or near energized components, confirm power is isolated per NFPA 70 (NEC) lockout-tagout requirements before using any power tool. Inspect bits for wear or deformation before each use and replace damaged bits promptly.