Dewalt DW5537B25 Sds Plus Carbide Hammer Bit 1/2in 25 Pack

Product Description

The DEWALT DW5537B25 is a bulk pack of 25 Solid Rock Carbide SDS Plus rotary hammer drill bits sized at 1/2 inch diameter with a 4-inch working length and 6-inch overall length. Designed for drilling into concrete, masonry, block, and hard stone, these bits use a full carbide tip to maintain edge integrity under the repeated impact cycles of an SDS Plus rotary hammer. The SDS Plus shank provides positive tool retention and allows the bit to float axially during hammering. This 25-count bulk configuration is suited for contractors and service crews that need consistent stock on active job sites.

These bits are used in residential and commercial construction, renovation, and infrastructure work wherever anchor holes, conduit penetrations, or structural fastener holes must be drilled through concrete or masonry. Typical applications include setting wedge anchors, sleeve anchors, and through-bolts, as well as drilling penetrations for mechanical, electrical, and plumbing rough-in work. The bulk pack quantity reduces per-bit cost for high-volume drilling operations.

Key Features

• Solid Rock Carbide tip engineered for concrete, masonry, and hard stone drilling
• SDS Plus shank for use with SDS Plus rotary hammers — provides positive engagement and axial float
• 1/2 inch diameter with 4-inch working length and 6-inch overall length
• Bulk pack of 25 bits reduces cost-per-hole for high-volume applications
• Full carbide construction maintains cutting edge through extended impact drilling

Compatibility

Designed for use with any SDS Plus rotary hammer accepting standard SDS Plus shank tooling, a format common across professional-grade rotary hammers used in concrete and masonry drilling.

Installation Notes

Installation should be performed by a qualified tradesperson familiar with rotary hammer operation and applicable building codes. Always disconnect the tool from its power source before inserting or removing bits, and confirm the bit is fully seated and locked in the SDS Plus chuck before drilling. Use appropriate personal protective equipment including eye protection and hearing protection when operating a rotary hammer. Do not use SDS Plus bits in drill-only mode for extended periods, as the bit and chuck are designed for combined rotation and hammer action.

Technical Specifications

• Bit Diameter: 1/2 inches
• Working Length: 4 inches
• Overall Length: 6 inches
• Shank Type: SDS Plus
• Tip Material: Solid Rock Carbide
• Pack Quantity: 25 bits
• Unit of Measure: Each (sold as 25-count pack)
• UPC: 885911094078

Standard Information

• Brand: DEWALT
• Manufacturer Part Number: DW5537B25