Dewalt DNS18075-2 18 Gauge Construction Staple 3/4 in Leg

Product Description

The DEWALT DNS18075-2 is an 18-gauge construction staple designed for pneumatic fastening applications in framing, sheathing, and general construction assembly. Each staple features a chisel point for clean material penetration and a copper finish for corrosion resistance. The leg length measures 3/4 inches with a crown width of 1/4 inch, making it well suited for light structural and substrate fastening tasks. Each package contains 2500 staples. These staples are installed by licensed contractors and finish carpenters using compatible pneumatic staplers.

These staples are intended for use in residential and light commercial construction settings where 18-gauge pneumatic staples are specified. Compatible pneumatic staplers accept the 1/4-inch crown format. Typical applications include fastening housewrap, underlayment, insulation batts, and similar sheet or roll materials to wood substrates. The 2500-count package is sized for production-rate work on job sites. DEWALT rates these staples for use with the DWFP1838 pneumatic stapler.

Key Features

• 18-gauge steel wire construction for consistent feeding and holding strength
• 3/4 inch leg length suitable for fastening medium-thickness substrates
• 1/4 inch crown width for secure material contact surface
• Chisel point geometry for clean, controlled penetration into wood
• Copper finish provides added corrosion resistance in exposed applications
• 2500 staples per package supports high-volume production fastening

Compatibility

Rated for use with the DEWALT DWFP1838 pneumatic stapler. Designed for 18-gauge, 1/4-inch crown pneumatic staple tools accepting 3/4-inch leg staples.

Installation Notes

These staples are installed using a compatible pneumatic stapler; disconnect the air supply before loading or clearing jams. Verify tool compatibility and confirm the correct leg length for the substrate thickness before driving. Follow all applicable fastener schedules referenced in local building codes when used in structural or code-governed assemblies. Do not use in applications requiring a specific rated fastener without confirming code compliance.