Dewalt DNS18063-2 Construction Staple 5/8 in 18 Ga 2500 Pack

Product Description

The DEWALT DNS18063-2 is an 18-gauge construction staple designed for use with compatible DEWALT pneumatic staplers. Each staple features a chisel point for clean, consistent penetration and a copper finish that resists corrosion during typical construction applications. The leg length measures 5/8 inches with a 1/4-inch crown width. Sold in a 2500-count pack, this staple is intended for professional installers and trade contractors who require a reliable, high-volume fastener for framing, sheathing, and general construction fastening tasks. The steel construction provides the tensile strength needed for structural and semi-structural applications.

These staples are suited for residential and light commercial construction work where a narrow-crown, 18-gauge staple is the specified fastener. Typical applications include fastening building wrap, roofing underlayment, insulation batts, and similar sheet or roll materials to wood substrates. The 2500-count box supports high-volume production work, reducing reload frequency on the job. These staples are compatible with the DEWALT DWFP1838 pneumatic stapler as specified by the manufacturer.

Key Features

• 18-gauge steel construction for reliable holding strength in wood substrates
• 5/8-inch leg length for secure fastening through sheet and roll materials
• 1/4-inch crown width for consistent fastener footprint
• Chisel point for clean, controlled penetration
• Copper finish provides corrosion resistance in standard construction environments
• 2500-count pack supports high-volume production work

Compatibility

Designed for use with the DEWALT DWFP1838 pneumatic stapler as stated by the manufacturer. Verify staple gauge, crown width, and leg length against your tool's specification sheet before loading.

Installation Notes

Installation is performed by a qualified carpenter, framing contractor, or general construction tradesperson using a compatible pneumatic stapler. Always disconnect the air supply before loading or clearing staples from the tool. Follow the tool manufacturer's recommended operating pressure range to avoid overdriving or underdriving fasteners. Verify that the selected leg length provides adequate penetration depth into the substrate per applicable building codes.