Dewalt DNS18050-2 18 Gauge Construction Staples 2500 Pack

Product Description

The DEWALT DNS18050-2 is an 18-gauge construction staple designed for fastening applications in residential and light commercial jobsites. Each staple features a 1/2-inch leg length, a 1/4-inch crown width, a chisel point tip for clean material penetration, and a copper finish over steel construction for corrosion resistance. Sold in a 2,500-count package, this staple is sized for compatibility with pneumatic staple guns used in sheathing, house wrap, insulation backing, and similar construction fastening tasks. Licensed contractors, framers, and general construction tradespeople are the primary installers.

These staples are suited for residential construction and remodeling applications where a standard 18-gauge crown staple is specified. The chisel point allows for consistent driving into wood framing, OSB, and similar substrates. The 2,500-count pack is designed for production-volume work where refill frequency must be minimized. Per supplier data, these staples are specified for use with the DWFP1838 pneumatic stapler.

Key Features

• 18-gauge steel construction for consistent strength and drive performance
• 1/2-inch leg length for secure fastening depth in standard substrates
• 1/4-inch crown width for broad holding surface
• Chisel point tip for clean, controlled material penetration
• Copper finish for added corrosion resistance
• 2,500 staples per package for high-volume production use

Compatibility

Specified for use with the DEWALT DWFP1838 pneumatic stapler per manufacturer data.

Installation Notes

Load staples into a compatible 18-gauge pneumatic stapler following the tool manufacturer's loading instructions. Disconnect the air supply before loading or clearing a jam. Set the compressor to the operating pressure specified by the staple gun manufacturer for the substrate being fastened. Inspect staples for damage or deformation before use and discard any bent or malformed fasteners.